Thermal Mass Flow Controllers

Thermal mass flow controllers that measure gas mass flow and drive a built-in valve to hold the setpoint. Aluminium or 316 stainless steel bodies with analog 0-5 V / 4-20 mA and RS-232/485 digital control, for ranges from 10 smL/min to 1000 sL/min N2 — from Aalborg Instruments and ANALYT-MTC.

All models

2 models
  • GFC

    Thermal gas controller with integrated solenoid valve and tiltable LCD; aluminium or stainless.

    ±1% FS · to 1000 sL/min

    ANALYT-MTC
    Details →
  • DFC Mass Flow Controller

    Digital thermal gas controller with RS-232/485, totalizer and flow and pressure alarms.

    ±1% FS · to 100 sL/min

    Aalborg
    Details →

How do I choose a thermal mass flow controller for gas?

Both controllers measure gas mass flow with a heat-transfer sensor and drive a built-in valve to the setpoint. Pick by what you need around the valve. The GFC is a thermal gas controller with an integrated solenoid valve and a tiltable LCD, in aluminium or stainless steel, reaching 1000 sL/min, with ±1% FS on the GFC 17, 37 and 47. The DFC Mass Flow Controller is a digital thermal gas controller with RS-232/485, a totalizer and flow and pressure alarms. Its range goes to 100 sL/min, also with ±1% FS.

Response to the setpoint is 1–5 s across the GFC models and, for the DFC, 1.0 to 2.0 second.

What should I check before ordering a gas mass flow controller?

Start with the control signal. Both give a linear 0-5 Vdc output; 4-20 mA is standard on the GFC and optional on the DFC, and the DFC adds digital RS-232/485 control. Then check line pressure: the DFC is rated to 70 bar(g), the GFC 17, 37 and 47 to 70 barg.

Check the gas and body material as well. Gas temperature is 0°C to 50°C on both, calibration is performed at standard conditions of 1013 hPa and 21.11°C, and the DFC is for dry gases only. The GFC comes in an aluminium or 316 stainless steel body; the DFC uses 316 stainless steel.

If you only need to read the flow, not hold it, see the thermal mass flow meters.

Questions about these products?

Our application engineers aim to reply within 3 business hours.

Ask an engineer